This board is the original upgrade version, update with OSD. It is designed to work with current BeeDuctrix / Tiny Whoop / Inductrix setups/Eachine E010 E010C E010S, just replace the current board with our new BeeCore mainboard and experience the next level of flight control.
ESC: All FETs are rated at 10A maximum
Work voltage: 3.7v-5v / 1S Lipo battery input
Firmware Version: BETAFLIGHTF 3.2.0
OSD: Built-in BetaFlight OSD (STM32 controls OSD chip over SPI in DMA mode)
Size: 26mm x 26mm (Fully compatible with the Inductrix quad and Eachine E010/E010S frame and mounting pattern.)
Receiver option: Frsky 8CH protocol D8 Mode (SBUS)
Flysky 6CH AFHDS 2A protocol (IBUS)
Spektrum- DSM2/DSMX protocol
1.The world’s first F3_EVO controller compatible for Frsky/Flysky/DSM2 (Optional).
2.BETAFLIGHTF ready, born for acro flight controller for the BeeDuctrix / Tiny Whoop / Inductrix quad!
3.Full Cleanflight/Betaflight compatibility on a STM32 F303 F3_EVO 3×1 style processor.
4.Fully programmable through Cleanflight / Betalfight using the onboard USB port! Tune all the parameters, PID’s, and rates to your perfect settings!
5.High discharge battery connector wire for more power and performance.
6.Can fly your Inductrix style quad in full rate mode (or even air mode!), fully execute flips/ rolls, and shoot the smallest of gaps with precision! Tuned to give you that locked in feeling you get with standard race quads.
1.Frsky Receiver Support FRSKY X9D/X9D PLUS(D8 mode),and XJT (D8 Mode),DJT DFT DHT Transmitter.
2.Flysky Receiver Support Eachine i6, FS-i4, FS-i6, FS-i6S, FS-i6X, FS-i10, FS-GT2E, FS-GT2G, FS-GT2F, Turnigy Evolution Transmitter.
3.Spektrum- DSM2/DSMX Receiver Support Spectrum/JR(DSM2/DSMX protocol) DEVO10/DEVO 7E(with deviation firmware).
1 x Beecore V2.0 Flight Control Board
3 x Power Cable (For Inductrix x1, For E010x1, For QX Serials x1)
4 x Rubber Shock Absorber
4 x Screws